Cleaning Instructions

1. Let the Suppressor Cool

                Never clean it hot. Allow it to cool completely to room temperature.

2. Initial Carbon Removal

                Tap the suppressor      gently to knock loose carbon free.

                Use compressed air to      blow out loose debris.

3. Apply Cleaner

                Spray Tipton Best Gun Degreaser throughout the internal cavities.

                Allow it to soak:

                Light fouling: 5 minutes   

      Do not leave strong solvents soaking overnight.

4. Scrub

           Using only non-metallic brushes:

• Scrub blast chambers
• Scrub baffles
• Scrub end cap areas

5. Degrease (Heavy Carbon Only)

                If the suppressor is extremely dirty:

               1. Spray KRUD KUTTER on the fouled areas.

               2. Let sit 2–3 minutes.

               3. Scrub again with nylon brush.

               4. Rinse thoroughly with warm water.

6. Dry Completely

• Blow out every cavity with compressed air.
• Allow to air dry 24 hours if water was used.
• Permissible to use a filament dryer or dehydrator at 120–140°F (50–60°C) for one hour.

7. Final Protectant

            Apply a very light coat of white lithium grease to:

• Threads

            Wipe away excess.

            Do not saturate the Core with oil.